Illustrated Physics
physics, drawn
Concept

Lenz's law — where it appears

The rule that an induced current opposes the change in flux that produced it, which is conservation of energy expressed as a sign. Reverse it and a magnet dropped through a coil would accelerate while generating power, so the sign is not a convention but a requirement.

Named by 6 essays across 2 fields — each of them below, with the objects they name alongside it.

A loop leaving the field. A rectangular loop of wire 0.3 metres by 0.2 metres moving at 1.5 metres per second out of a region of magnetic field of 0.6 tesla directed into the page, marked with crosses. 0.08 metres of the loop's width is still inside the field. The induced current runs clockwise, and the force on the side that is in the field opposes the motion.

The field that makes the other, and only while it is changing

A magnet sitting next to a coil does nothing at all. Move it and a current flows. The law is not about the field but about its rate of change, and everything electrical since 1831 rests on that distinction.

electromagnetism · Induction What a collapse does to a field. A body of radius 700,000 km carrying a field of 0.01 T, collapsing to 10 km. The flux through every comoving loop is fixed, so B goes as 1/R² and the field reaches 4.9·10⁷ T — a compression of 7·10⁴ in radius bought a factor of 4.9·10⁹ in field. The line has slope exactly −2 and that is the only claim being made: what a real object ends up with also depends on how well the flux was held, and on what generated it.

The field that cannot get out

Squeeze a lump of conducting fluid and its magnetic field comes with it, because the flux through any loop that moves with the material cannot change. Halve the radius and the field goes up fourfold; collapse by a factor of seventy thousand and it goes up by five thousand million.

astrophysics · Flux freezing A metre of tube, with and without the metal. The magnet's position against time over a 1.00 m drop, integrated from Newton's second law with the eddy-current drag included, and the same fall with the drag switched off. The braked descent takes 2.09 s against 0.45 s in free fall. After a transient of about 50 milliseconds — the mass divided by the drag coefficient, and the only timescale in the problem — the trace is a straight line, which is to say the magnet is falling at a constant 49.0 cm/s. Every joule of the 118 mJ of gravitational energy released has gone into resistive heating of the wall, and none into the magnet's kinetic energy, since that is the same at the bottom as it was a moment after the start.

The magnet that falls slowly

Drop a magnet down a copper pipe and it takes several seconds to fall a metre, drifting rather than falling. Nothing touches it, the copper is not magnetic, and there is no circuit anywhere. The pipe arrives warm.

electromagnetism · Induction A disc that generates 0.785 V with no changing flux anywhere. The force per unit charge on a carrier in a conducting disc of radius 100 mm spinning at 3000 revolutions a minute in an axial field of 0.5 tesla, against how far out the carrier is. Each carrier is moving through the field at ωr, so v × B pushes it radially with a force per unit charge of ωrB — zero at the axle and largest at the rim. The area under the line is the potential difference between the axle and the rim, which is ½BωR² = 0.7854 volts. Nothing in this calculation mentions a loop, a flux or a rate of change, and the flux through the circuit formed by the disc, the contacts and the external wire does not change at all while the machine runs.

The rule that is two laws wearing one coat

The flux rule folds two entirely different pieces of physics into one number, and they agree exactly, which is why nobody notices there are two. A disc spinning in a steady field generates a voltage with no changing flux anywhere, and the folding comes apart.

electromagnetism · Induction How much of μ₀N²A/ℓ a real coil actually has. The inductance of a 140-turn coil of radius 10 mm, divided by the long-solenoid formula μ₀N²A/ℓ, against how long the coil is compared with its diameter. The inductance is computed as a sum of Maxwell's mutual inductances between every pair of turns plus each turn's own, so the long-coil formula appears nowhere in it. At a length equal to the diameter the real coil has 68% of what the formula promises, and at a quarter of the diameter about a third. The reason is that the formula assumes every turn is threaded by the full interior field, and near the ends of a short coil the field has already begun to spread. The ratio is Nagaoka's coefficient, tabulated since 1909, and the computed points agree with the table.

The circuit that fights its own change

Every circuit is threaded by the field its own current makes, so every circuit resists having that current altered. It is the reason a coil takes time to start and the reason breaking one makes a voltage a thousand times the supply's.

electromagnetism · Induction The drag peaks and then gives way to lift. The two forces on a magnet moving parallel to a thin conducting sheet, as fractions of the repulsion a perfect mirror image would exert, against the magnet's speed divided by the sheet's characteristic speed w = 2/μ₀σd, on a logarithmic axis. Drag grows in proportion to the speed at first, peaks at 1.27 w with 0.300 of the full repulsion, and then falls as w/v. Lift starts as the square of the speed, equals drag at v = w, where both are 0.293, and approaches the full repulsion at high speed: 0.900 at 10 w. The same eddy currents cause both. What changes with speed is how much of the image they form has time to sink away before the magnet has passed.

The drag that falls as the magnet speeds up

Drop a magnet down a copper pipe and it creeps, because the currents it stirs up in the metal pull back on it in proportion to its speed. Push it faster and the proportion fails: the drag rises to a peak and then falls away, while a second force, pointing straight up, grows to replace it. A magnet moving fast enough over a sheet of aluminium is not braked but held up, with lift thirty times its drag at the speed of a fast train, and the reason is that at high speed the metal has no time to forget the magnet has passed.

electromagnetism · Induction

Named alongside it

The objects these essays reach for when they reach for this one.

Electromagnetic inductionMagnetic fluxEmfFaraday's lawEddy currentsEnergy conservationField linesFlux freezingCircuitConductivityConductorsConservation laws

All concepts