Illustrated Physics
physics, drawn
Concept

Emf — where it appears

The work done per unit charge in driving current round a circuit, measured in volts and produced by something other than a static electric field. Calling it a force is a historical accident: it is an energy per charge, and its source may be chemical, thermal or a changing magnetic flux.

Named by 3 essays across one field — each of them below, with the objects they name alongside it.

A loop leaving the field. A rectangular loop of wire 0.3 metres by 0.2 metres moving at 1.5 metres per second out of a region of magnetic field of 0.6 tesla directed into the page, marked with crosses. 0.08 metres of the loop's width is still inside the field. The induced current runs clockwise, and the force on the side that is in the field opposes the motion.

The field that makes the other, and only while it is changing

A magnet sitting next to a coil does nothing at all. Move it and a current flows. The law is not about the field but about its rate of change, and everything electrical since 1831 rests on that distinction.

electromagnetism · Induction A disc that generates 0.785 V with no changing flux anywhere. The force per unit charge on a carrier in a conducting disc of radius 100 mm spinning at 3000 revolutions a minute in an axial field of 0.5 tesla, against how far out the carrier is. Each carrier is moving through the field at ωr, so v × B pushes it radially with a force per unit charge of ωrB — zero at the axle and largest at the rim. The area under the line is the potential difference between the axle and the rim, which is ½BωR² = 0.7854 volts. Nothing in this calculation mentions a loop, a flux or a rate of change, and the flux through the circuit formed by the disc, the contacts and the external wire does not change at all while the machine runs.

The rule that is two laws wearing one coat

The flux rule folds two entirely different pieces of physics into one number, and they agree exactly, which is why nobody notices there are two. A disc spinning in a steady field generates a voltage with no changing flux anywhere, and the folding comes apart.

electromagnetism · Induction How much of μ₀N²A/ℓ a real coil actually has. The inductance of a 140-turn coil of radius 10 mm, divided by the long-solenoid formula μ₀N²A/ℓ, against how long the coil is compared with its diameter. The inductance is computed as a sum of Maxwell's mutual inductances between every pair of turns plus each turn's own, so the long-coil formula appears nowhere in it. At a length equal to the diameter the real coil has 68% of what the formula promises, and at a quarter of the diameter about a third. The reason is that the formula assumes every turn is threaded by the full interior field, and near the ends of a short coil the field has already begun to spread. The ratio is Nagaoka's coefficient, tabulated since 1909, and the computed points agree with the table.

The circuit that fights its own change

Every circuit is threaded by the field its own current makes, so every circuit resists having that current altered. It is the reason a coil takes time to start and the reason breaking one makes a voltage a thousand times the supply's.

electromagnetism · Induction

Named alongside it

The objects these essays reach for when they reach for this one.

Electromagnetic inductionLenz's lawEnergy conservationFaraday's lawField linesMagnetic fluxCircuitField energyFluxThe Lorentz forceMagnetic fieldMaxwell equations

All concepts