Concept

Sea level — where it appears

The mean height of the sea surface, rising when ice on land melts into the ocean and when the water warms and expands. Thermal expansion adds height and no mass, so it raises the sea without changing the pressure on the sea floor.

Named by 4 essays across one field — each of them below, with the objects they name alongside it.

Water gets denser the deeper it is. The density of seawater at 0 °C and a salinity of 35 against depth, from the surface to the 10.99 km of the Challenger Deep, with the pressure integrated down the column from the equation of state rather than assumed. At the surface it is 1028.1 kg/m³. At the ocean's mean depth of 3.68 km it is 1045.3, 1.67 per cent more; at the bottom of the deepest trench it is 1076.5, 4.71 per cent more. An incompressible ocean would be the vertical line. The curve is almost straight; what curvature it has, too little to see here, is the water stiffening as it is squeezed: its secant bulk modulus rises by 3.24 pascals for every pascal of pressure.

The sea that stands lower because water gives

Water is the textbook incompressible fluid, and at the bottom of the ocean it is 4.7 per cent denser than at the top. That squeezing lowers the whole sea by about thirty metres, adds the weight of 266 metres of water to the pressure in the deepest trench, and speeds sound up so steadily with depth that it digs a channel in which a low note can cross an ocean.

fluids · Hydrostatics
The rise a watt-year buys at each depth. The rise in sea level, in millimetres, from one watt-year per square metre of heat (3.16 × 10⁷ joules) stored in a thin layer at each depth, for two water columns: a subtropical one, 24 °C at the surface cooling to 1.5 °C in the deep, and a polar one, 1.5 °C at the surface and 0.5 °C below. In the warm column the yield is 2.36 mm at the surface, falls to 1.02 mm near 2.0 km where the water is cold but the pressure still modest, and recovers to 1.49 mm at 6 km as pressure takes over. In the polar column the same heat buys 0.63 mm at the surface and 1.13 mm at 4 km. A joule stored in cold, deep water raises the sea about twice as much as one stored in the cold water above it.

The rise a joule of heat buys

Warm a column of seawater and it stands taller without weighing any more, so the sea rises while the pressure on the sea floor stays exactly the same. How much it rises depends on where the heat goes. Seawater's expansion coefficient grows with temperature and with pressure, so a joule stored in warm tropical water lifts the sea more than six times as far as the same joule in Arctic surface water. Cold water in the deep, squeezed by four kilometres above it, expands about twice as much per joule as the same cold water at the surface. That is why the budget of sea-level rise turns on thousandths of a degree in the least-measured part of the ocean.

fluids · Hydrostatics
Where the level goes when a floating ice cube melts. The change in level when a 30 g ice cube floating in a glass 7 cm across has melted completely, against the density of the liquid it floats in (the liquid must be denser than ice, 917 kg/m³, or the cube sinks). In fresh water the level does not move: the meltwater exactly fills the volume the ice displaced. In seawater it rises 0.21 mm and in saturated brine 1.3 mm, because the ice was displacing a denser liquid than it melts into; in castor oil, which is lighter than water and does not mix with it, the level falls 0.32 mm as the meltwater sinks beneath the oil. The change is the meltwater's volume minus the displaced volume, m/ρw − m/ρ, spread over the glass.

The floating ice that still raises the sea

An ice cube melting in a glass of water leaves the level exactly where it was, and the reason is exact: a floating body displaces its own weight, and the meltwater has that weight. The same argument is often used to say that melting sea ice and ice shelves cannot raise the sea. It nearly works. The ice was floating in salt water and melts into fresh, which is lighter, so the meltwater overfills the hole by almost three per cent — and the ice that really fills the sea is the part of a grounded glacier above the thickness at which it would float.

fluids · Buoyancy
An ice sheet resting on a bed below the sea. A section along the flow of an ice sheet on the MISMIP benchmark bed, which lies below sea level beyond 480 km from the divide and deepens inland between 974 and 1265 km. Dashed: the height the ice surface would stand at if the ice were just thick enough to touch the bed — 1.11 times the water's depth thick, a ninth of it above the sea. At the rate factor drawn, the balance of snowfall against export has three solutions: grounding lines at 800, 1124, 1376 km. The outer two are stable; the middle one, on the stretch where the bed deepens inland, is not. The ice drawn — its surface a plastic profile, a sketch rather than a solution — rests on the bed out to 1376 km, where it must be 803 m thick to touch it, and floats beyond as a shelf.

The grounding line with nowhere to stop

Where an ice sheet flowing into the sea lifts off its bed and begins to float, buoyancy fixes how thick it is: just thick enough to touch the rock, about 1.1 times the depth of the water. The ice crossing that line goes as the 19/4 power of the thickness, so twice the depth sends out twenty-seven times the ice. On a bed that deepens inland, a grounding line that retreats a little moves into deeper water, exports more, and retreats further. No steady state can sit there, and an ice sheet whose edge reaches such a slope crosses the whole of it.

fluids · Buoyancy

Named alongside it

The objects these essays reach for when they reach for this one.

BuoyancyCompressibilityDensityEquation of stateFlotationHydrostatic pressureArchimedes principleBulk modulusGrounding lineHysteresisIce sheetIce shelf

All concepts