Illustrated Physics
physics, drawn
Concept

Fringing field — where it appears

The part of a field that bulges out beyond the edges of a device such as a capacitor or a magnet gap, where the idealised uniform-field picture ends. It adds to capacitance and inductance, and is largest when the gap is not small compared with the plates.

Named by 2 essays across 2 fields — each of them below, with the objects they name alongside it.

The only part of the field that can pull. A dielectric slab part-way into a parallel-plate capacitor. Everywhere except at the slab's edge the field is perpendicular to the plates and therefore perpendicular to the direction the slab can move, so it exerts no force along that direction at all: inside the parallel-plate model, which is uniform between the plates and zero outside them, nothing pulls the slab anywhere. The force lives in the bowed lines drawn at the edge, where the field leaks past the end of the dielectric and acquires a component along the plates. Those lines are what the model throws away as a small correction near the boundary, and they are the entire mechanism. The energy method sidesteps the drawing altogether: differentiate the total energy with respect to the insertion and the answer is 1.328e-3 newtons, inward, without ever asking where on the slab the force is applied.

The force that lives where the model is not

A slab of glass held at the mouth of a charged capacitor is pulled in. Inside the parallel-plate model there is no force at all — the field is perpendicular to the slab's motion everywhere — and the same model's energy nevertheless gives the pull exactly right. The mechanism is entirely in the part of the field the model throws away.

electromagnetism · Dielectrics An angle set by a voltage. The contact angle of water on a fluoropolymer coating with a rest angle of 115°, against the voltage across the coating, for coatings 1 and 3 µm thick with a relative permittivity of 1.93. The Lippmann–Young law cos θ = cos θ₀ + ε₀εᵣV²/2dγ makes the cosine rise as the square of the voltage, so the curve is symmetric about zero volts and steepest where the angle is near 90°. For 1 µm the law reaches complete wetting at 110 V; for 3 µm the law reaches complete wetting at 191 V. It does not get there. In most reported experiments the angle stops falling somewhere in the shaded band and then stays put however high the voltage is raised — contact-angle saturation — and why is still argued: charge trapped in the insulator, ionisation of the air at the sharp edge of the drop, and the thermodynamic stability of the contact line have all been proposed and none accounts for every case.

The angle a voltage can set

A contact angle is treated as a fact about three materials — a solid, a liquid and the air — fixed the moment they are chosen. Put a voltage across a micrometre of insulator under a drop and the angle falls as the square of the voltage, with nothing about the materials changed. Drops can be steered across a chip with no pump, and a lens can focus with no moving part. The law that describes it is exact in its model, and real surfaces stop obeying it at an angle nobody has fully explained.

fluids · Capillarity

Named alongside it

The objects these essays reach for when they reach for this one.

CapacitanceBatteryBound chargeCapillarityContact angleDielectricDielectrophoresisElectrostatic forceElectrowettingEnergy methodField energyFree energy

All concepts