Illustrated Physics
physics, drawn
Concept

Capillary pressure — where it appears

The pressure difference across a curved liquid surface, 2σ/r for a meniscus of radius r and surface tension σ. In a fine pore it pulls liquid along, and it is what lets a wick or a soil lift water against gravity, up to a height inversely proportional to the pore size.

Named by 2 essays across 2 fields — each of them below, with the objects they name alongside it.

The colours a draining film runs through, and the end of them. The fraction of light a free soap film reflects, against its thickness, at three wavelengths — 450, 550, 620 nm — computed from the sum over multiple reflections rather than from the two-beam approximation. The three curves peak at different thicknesses, which is why a draining film runs through a sequence of colours as it thins. Below about 11 nm every curve is under a tenth of a per cent and the film looks black. At zero thickness the reflectance is exactly zero, checked before the figure is drawn: the two surfaces reflect equally and half a cycle out of step, so a film much thinner than a wavelength cancels itself. That is the whole of why a black film is black. Nothing is absorbing; the film is there and has simply stopped being able to interfere constructively at any visible wavelength — which means the blackness is a measurement, and a film that has gone black is known to be thinner than about a tenth of a wavelength without anything being measured directly.

The film that goes black before it bursts

A soap film drains, runs through every interference colour, and then stops reflecting anything at all. The black patch is not a hole and not a film about to break: it is the thinnest and most stable state the arrangement has, held apart by a pressure between its two surfaces that only exists at distances of nanometres.

fluids · Surface tension The pipe that out-conducts any solid. The temperature difference needed to carry 30 W along a rod 300 mm long and 6 mm across, on a logarithmic scale: for solid aluminium 1343 K, for copper 796 K, for diamond, the best conductor of heat at room temperature, 159 K; and for a water heat pipe of the same size 0.8 K, almost all of it across the thin wet wicks where the heat goes in and comes out. Solid metal could not do it at all: the hot end of the copper rod would have to be hundreds of degrees above the cold. The heat pipe carries the heat as latent heat in moving vapour, and the vapour needs almost no temperature difference to flow. As an effective conductivity that is 1000 times copper's — which is why every laptop and many satellites move their heat in pipes rather than through metal.

The pipe that carries heat as vapour

A copper rod six millimetres across and thirty centimetres long, asked to carry thirty watts from a laptop's processor to its fan, would need its hot end eight hundred degrees above its cold end. The flattened copper tube that actually does the job manages it with less than a degree. It is a heat pipe: sealed, emptied of air, and holding a few drops of water and their vapour. The water boils at the hot end, the vapour rushes to the cold end and condenses, and a wick of sintered copper powder drags the liquid back by capillarity. The heat goes as latent heat, and vapour needs almost no temperature difference to flow — which makes the pipe a thousand times better than copper, as long as its wick can keep up.

thermodynamics · Phase change

Named alongside it

The objects these essays reach for when they reach for this one.

Clausius clapeyronCritical pointDisjoining pressureDrainageEquilibriumHeat pipeInterferenceLatent heatScreeningStabilitySurface tensionSurfactant

All concepts