The step that raises a body's voltage without adding charge
Assumes: How much charge a shape will hold, before anything is charged · The spark that needs room to start
Walk across a carpet on a dry winter day, reach for a metal door handle, and a spark jumps to it from a finger with a crack and a sting. The usual explanation stops at friction: shoes rubbing on carpet transfer charge, the body collects it, and the handle lets it go. That is true and leaves out most of what decides whether the spark happens and how big it is.
A charge on a conductor produces a voltage that depends on the conductor’s capacitance as well as its charge, , and a person’s capacitance is not fixed. It is dominated by the soles of the feet, and it changes every time a foot leaves the floor. Walking is a capacitor being pulled apart and pushed together twice a second. The surprise is that this alone, without adding any charge, raises the body’s voltage by half on every step.
A person as a capacitor
How much charge a shape will hold established that capacitance is fixed by geometry before any charge arrives: a conductor of a given shape and position has a number attached to it, the charge it takes to raise its potential by one volt. A human body is a conductor — salty water in a bag of skin, conducting well enough for every electrostatic purpose — and its shape and surroundings give it a capacitance.
Some of that capacitance is to the room at large. An isolated conducting sphere of radius has capacitance , about 110 picofarads for a sphere a metre in radius, and a standing person, tall and thin, is worth something like sixty to the room as a whole. The rest, and in shoes the larger part, is between the soles of the feet and the floor: two plates of skin and floor separated by a centimetre of rubber, each a sole’s area of about 250 square centimetres. A parallel-plate capacitor of that size with a dielectric of relative permittivity 3 has , 66 picofarads per foot. Add a few picofarads of fringe, and a person standing in shoes is about two hundred picofarads, which is the order measured.
That number is small. A charge of one microcoulomb on it would be five thousand volts.
Lifting a foot
A foot that leaves the floor takes most of its capacitance with it. The sole’s capacitance is now a layer of rubber in series with an air gap, , and five centimetres of air is fifteen times thicker, electrically, than the centimetre of rubber. The foot’s share drops from 69 picofarads to about 7.
The charge on the body has not changed. It cannot: there is nowhere for it to go. So its potential rises, , from 5 kilovolts standing to 7.3 with one foot five centimetres up. Both feet in the air, in a jump, leave only the body’s capacitance to the room and the fringe, and the same charge reaches about 15 kilovolts. The voltage is pumped up mechanically, by moving the plates of a capacitor apart against their attraction, and the energy comes from the leg that lifts the foot. It is a small force. Raising a foot five centimetres at this charge stores about a millijoule more in the field, which is an average pull of about the weight of two grams, the attraction the pressure a charge puts on its own metal found every charged surface feeling towards the field outside it. Nobody notices doing the work.
This is the principle of every electrostatic machine that works by separating plates. The water drops that charge themselves to a spark built kilovolts from falling drops by carrying charge away from where it was induced; a walking person does something simpler and more direct, separating a capacitor’s plates at constant charge. The phrase “electrostatic induction” covers both, and in both the voltage is a consequence of geometry acting on charge that is already there.
Charge that stays, voltage that does not
It is worth being clear about which quantity is conserved here and which is not, because everyday language runs them together. The body’s charge is fixed between steps; it is a count of electrons, and nothing in lifting a foot creates or destroys any. The voltage is not a property of the charge alone. It is the work per unit charge needed to bring a test charge from far away to the body, and that work depends on how the field around the body is arranged — how much of it is crammed into the thin layer under the soles, where a given charge makes a small potential because the opposite charge on the floor is so close, and how much spreads into the room, where the same charge makes a large one.
Lifting a foot moves field lines out of the sole and into the room. The charge is the same, the field is larger and more spread out, the energy stored in it, , is larger, and the potential is higher. The leg supplies the difference. Putting the foot down reverses it, and the energy returns, mostly, to the leg. A body walking at constant charge is therefore oscillating in voltage twice a second between about and one and a half times that, and the peaks, not the average, decide when a spark can jump.
There is a family resemblance to a quite different hazard. The stride that spans a lightning strike found a voltage between a person’s feet, imposed by current flowing through the ground; here the voltage is between the person and everything else, created by the person’s own feet leaving the ground. One is a potential difference across a stride, the other a potential lifted by one, and both make the act of walking electrically significant.
Charge in, charge out
Where the charge comes from is the part everyone knows. Two different materials pressed together and pulled apart exchange electrons, one taking a little negative charge and the other a little positive, by amounts that depend on the materials’ places in the triboelectric series and on how hard and how often they touch. A rubber sole on a wool or nylon carpet leaves with a charge every time it lifts. A few nanocoulombs a step is typical.
Charge also leaks away, through the shoes, the floor and the air, and the body’s voltage is set by the balance. A body of capacitance leaking through resistance loses charge with time constant ; fed a charge at every step at rate , it settles where the leak carries off as much as the steps bring, at .
The figure follows a walker separating ten nanocoulombs a step. With a leak of ohms — leather soles, a damp floor — the body settles within seconds at a couple of hundred volts and never sparks. With ohms — rubber soles on a synthetic carpet in dry air — the time constant is minutes and the voltage is still climbing after two minutes’ walk, past eight kilovolts. Between those, every factor of ten in the leak resistance is a factor of ten in the voltage. And the plotted values are the low points of each stride, with both feet down. Halfway through each step, with one foot up, the voltage is half as high again.
Winter air turns a carpet into a charge pump
The leak resistance is where the weather comes in. Air itself is an excellent insulator at all humidities; what conducts is the thin film of water that every surface adsorbs from the air, a few molecular layers thick, carrying ions. Its conductivity rises steeply with humidity, and the surfaces of a carpet, a shoe and the skin go from good insulators in dry air to poor ones in damp air.
The two fixed points of the figure are the values quoted in the electronics industry’s standard tables of how much voltage everyday activities generate, and the line between them is a logarithmic interpolation, not a measurement. It is enough to show the scale of the effect: a factor of twenty in the voltage between a dry room and a damp one, and a crossing of the threshold of feeling somewhere in the sixties. Outdoor air in winter can be very humid at its own temperature, but heated indoors from near freezing to twenty degrees it holds the same water at a quarter of its saturation, and indoor humidity in a heated building in a cold climate is often around twenty per cent. That, not the cold, is why shocks are a winter phenomenon.
The film of water is also what makes humid days safe for electronics, and dry days a hazard: the manufacturing rooms where chips are handled are humidified, and their floors and benches made deliberately slightly conducting, so that the leak resistance is low and no body ever reaches a damaging voltage.
A spark jumps before the finger arrives
At some point the walker reaches for a handle. As the finger approaches the metal the field between them grows, concentrated by the fingertip’s curvature as the charge that follows no local rule found charge crowding at the sharp parts of a conductor, and when the field across the shrinking gap reaches the breakdown strength of air, the gap fires.
The spark that needs room to start derived the breakdown curve, which depends on the gap and the pressure only through their product, and found its floor: no gap in air at atmospheric pressure breaks down below about three hundred volts. For a body, that floor means charges below a few hundred volts leak away silently, and above it the gap at which the spark jumps grows roughly in proportion to the voltage. A three-kilovolt body fires across half a millimetre, nearly touching; a ten-kilovolt body across more than two. That is why a bad shock seems to leap out of the handle: it does, from a visible distance, and the finger is still moving when it arrives.
The lifted foot matters here too. A person reaching for a handle while stepping — one foot in the air — carries half as much voltage again as one standing still, and the spark jumps a correspondingly longer gap. Touching a handle in mid-stride is the worst way to do it.
Amperes for a tenth of a microsecond
The discharge itself is brief and, by the standards of electricity, large. The standard model engineers use to test electronics against human discharges represents a person as 100 picofarads discharging through 1,500 ohms of skin and body resistance.
A ten-kilovolt body delivers a peak of nearly seven amperes, decaying in 150 nanoseconds; the energy is five millijoules, about what it takes to lift a grain of rice by a metre. It hurts not because there is much of it but because it is concentrated: the spark enters the skin through a spot a fraction of a millimetre across, where the current density is enormous for a moment, and the nerve endings in a fingertip are dense. Holding a key and letting the spark land on the key instead moves the arc to the metal; the current then enters the hand through the whole area of the grip, and the same discharge is not felt at all.
For a microchip, the same pulse is not a sting but a weapon. A transistor’s gate oxide, a few nanometres thick, breaks down at a few volts, and seven amperes through a pin can melt a junction. The standard model exists because electronics manufacturers needed to know what a human hand delivers, and the answer is that it delivers kilovolts that the hand’s owner never feels.
The car door, and the sharp point that bleeds charge quietly
The same capacitance effect explains the shock that comes from getting out of a car. Sliding across a seat separates charge between clothing and upholstery; sitting, the body is a large plate pressed against the seat a few millimetres away, with a capacitance of hundreds of picofarads to the car. Standing up pulls that plate away, the capacitance falls several-fold, and the charge already separated is suddenly at many kilovolts relative to the car. Reaching back to close the door completes the circuit through a spark. Holding the metal frame while getting out keeps the body joined to the car as the plates separate, so the charge flows away through the hand as the voltage rises, harmlessly, before it can build. A car’s body is otherwise an excellent shelter from electricity, the property the inside of a conductor explained; the shock comes from the person carrying their own separated charge across the threshold.
Not every discharge is a spark. A sharp point concentrates the field at its tip so strongly that the air there breaks down in a small, continuous glow long before a spark could jump to anything, the corona that the glow a thin wire wears before it sparks followed on high-voltage lines. Antistatic brushes on printers and the grounded tinsel once trailed behind fuel trucks work this way: thin fibres and points bleed charge off continuously, keeping the voltage below the level at which a single large spark could form. The difference between a sting and nothing is not how much charge is removed but how quickly, and through what.
What the model leaves out
The capacitance model is a sketch: sixty picofarads to the room is an estimate, the soles are treated as parallel plates with a fixed fringe, and a real foot lifts heel first and rolls, so its capacitance changes continuously rather than switching. Measurements of human capacitance in shoes span roughly 100 to 300 picofarads, and the pumping effect of a lifted foot depends on how much of the total the soles contribute, which depends on the shoe. The direction and rough size of the effect — a lifted foot raises the voltage by tens of per cent — survive any reasonable choice.
The charging is treated as a fixed charge per step, and the leakage as a single resistance, both of which in reality depend on the materials, the walking style, the temperature and the humidity in ways that only measurement settles. The humidity figure is an interpolation between two published values, and the threshold of feeling, about three kilovolts, varies between people and with where on the body the spark lands. Paschen’s law describes breakdown between flat electrodes; between a fingertip and a curved handle the field is not uniform, and the breakdown voltage for a given gap is somewhat lower. None of these change the logic: the body’s voltage is its charge over a capacitance that its posture changes.
Still open: what happens in the first nanosecond
The human-body model is a circuit chosen to make tests reproducible, not a description of what happens in a real spark. Measurements of actual hand discharges show a much faster initial spike, with rise times well under a nanosecond and peak currents that depend strongly on how fast the hand was moving when the spark formed — a fast approach produces a shorter, sharper spark than a slow one at the same voltage, because the arc forms across a shorter gap before the field has had time to drive breakdown at a longer one. That fast component is what disrupts electronics most, and how it depends on approach speed, humidity and the shape of the hand and the metal is still being characterised for the newer, faster test standards.
A person in shoes is a capacitor of about 200 pF, most of it through the soles, so lifting one foot 5 cm cuts the capacitance to about 136 pF and raises the voltage of whatever charge the body carries by half — 5 kV becomes 7.3, a jump takes it near 15 — while walking on carpet adds charge each step that leaks away only through 10¹⁰ to 10¹² Ω of shoe and floor, so the body climbs to tens of kilovolts in dry indoor air and a few hundred volts in damp; the spark then leaps a gap of about a millimetre per few kilovolts, delivering amperes for 150 ns and a few millijoules concentrated on a fingertip. The shock is charge, divided by a capacitance that every step changes.
Part 12 of 13
This essay is one argument about Conductors. The others:
The objects named here
The third axis, after the field and the reading path: the things themselves, and every essay that touches each one.
CapacitanceElectrostatic dischargePaschen lawRelative humidityTime constantTriboelectric effect